How to run device Clone Consult 3 in program Renault Clip?

Welcome Guest, Not a member yet ?

Latest news:

---- Nissan NERS 4.01 With Calibration Files Mega ---- BMW ISPI ISTA LAUNCHER 1.60.06.2036 FILES MEGA ---- GDS2 Install Complete + Keygen FULL ---- Benz Seed Calc Seed Key Calculator Tool ---- WinOLS 5.80.64Bit File Full ---- VAG ODIS-S 260001.101.180 FILES MEGA ---- VAG ODIS-E 220000.401.10 FILES MEGA ---- Nissan Consult III + Programming Data 226 Files Mega ---- XENTRY OFFLINE LOGIN FIX 12.2025 FULL ---- Renault Dacia DCM Program Full ---- DIAGBOX 9.85 + ACTIVATION FULL ---- PSA MD1CS003 EDC17C60 TPROT REMOVER ---- Peugeot Key Calculator + Keygen ---- Cummins InPower 16 Files Mega ---- Flex Fuel Energy Development Tool Full ---- Citroen C2 Repair Manual ---- Ford IDS 133.01 + Patch Full ---- SCANIA MULTI 25.50.0.0 [2025.09] FILES FULL ---- Toyota Lexus Global Electronic Parts Catalog 2025 Full ---- Bosch ESI [tronic] 2013 Full + Keygen VM Full ---- WINOLS 47 NATIVE INSTALLER FULL ---- BMW E-Sys Setup 3.33.0-53640 Files ---- RANGE ROVER VELAR WORKSHOP REPAIR MANUAL ---- DAF DAVIE 5.6.1 95.00 XDC II FILES MEGA ---- How To Flash NBTevo With E-Sys Tutorial ---- Microsoft Activation Windows Office 07.2026 ---- Honda HDS 3.105.036 + i-HDS 1.009.001 Files 2025 ---- Delphi Autocom Firmware 1622 Modified ---- Toyota ISTA J29 v4.58.41 Full ---- Hello everyone! ----

sldryl Offline

Junior Member

05-27-2025, 12:03 PM

Hello very dear Automotiveforum members,

I have 50 Clone Consult 3 devices. Renault Clip v178 is installed on Windows 7 32 Bit operating system. When I plug the device into the computer, it appears as "Unknown device" in the device manager. What should I do to run this device in the Renault Clip program? I think this is a driver file problem or something else. Can anyone help me with this? I have added detailed photos of the device.

Attached Files Thumbnail(s)

Thanks given by: lennoxpaul , seby001

Users browsing this thread:

1 Guest(s)